Canon imagePROGRAF GP-4000 - Manual (Page 257)

Selecting Enable HTTPS redirection redirects the communication using CHMP to encrypted
communication.
Note
• To use CHMP for encrypted communication, you need to register the printer's root certificate to
your computer.
Registering Printer's Root Certificate to Local Computer for SSL Communication
• CHMP is a Canon proprietary protocol.
◦ Network interface settings ◦
To connect to a hub that supports STP, select Enable .
Selecting Enable perform the intermittent data reception when connecting to the network.
◦ DRX settings ◦
Selecting Enable perform the intermittent data reception when connecting to the network.
◦ IP filtering ◦
Allows or denies access for specific IP addresses.
Settings for both IPv4 and IPv6 addresses can be specified.
Important
• If the device address for the administrator has been set to rejection by mistake, initialize the •
printer's network information, and then perform setup again.
LAN settings > Wi-Fi / Wireless Direct / Wired LAN > Settings > Advanced setup > Reset
LAN settings
◦ MAC address filtering settings ◦
Allows or denies access for specific MAC addresses.
Important
• If the device address for the administrator has been set to rejection by mistake, initialize the •
printer's network information, and then perform setup again.
LAN settings > Wi-Fi / Wireless Direct / Wired LAN > Settings > Advanced setup > Reset
LAN settings
◦ Reset LAN settings ◦
Initializes the network settings on the printer.
After resetting, perform setup again as necessary.
257