Huawei DR814Q - Manual (Page 12)

User Manual
Aolynk DR814Q ADSL2+ Broadband Router
2 Installation
7
II
To conn
C, Hub, or switch to the
Ethernet port (one among LAN1 through LAN4) of the DR814Q.
Connect your PC to the DR814Q through the USB ports with a USB cable. It is
uitable for the PC without NIC to access the Internet.
. Connect to a PC or Ethernet
ect the DR814Q to a PC or Ethernet, two options are available:
z The Ethernet ports of the DR814Q are auto-MDI/MDIX, so you can use the
crossover or straight-through cable to connect your P
z
s
Caution:
To use the USB port on the DR814Q, you must install the USB driver and configure
your PC (refer to section 8 “Appendix - USB Configuration” for detailed information).
I. Connect to the power adapter II
r-on of the DR814Q, the states of the LEDs on
the fr nel should b listed in Table 2-2.
Table 2-2 Descr the LED state
Attach one end of the power adapter to the DR814Q and the other end to the power
outlet. The DR814Q has no power switch, so it is powered on as soon as you plug the
power adapter into the power outlet.
Approximately one minute after the powe
ont pa e those
iption of s
LED State Description
Power Green —
Link Green —
Blinking eived. Data is being transmitted and rec
Act
OFF No data transmission is present.
Green The Ethernet link is established.
LAN
Blinking
Data is being transmitted and received on the
Ethernet port.