Huawei DR814Q User Manual
Page 49
User Manual
Aolynk DR814Q ADSL2+ Broadband Router
5 Advanced Configuration
44
z
Bind other two LAN ports to PVC 0/100, and the PCs connecting to these ports
access the Internet through PPPoE dial-up connections.
z
Route the last LAN port to access the Internet and apply NAT-enabled PPPoE
service on this port. Bind it to PVC 8/35. The user name and password your ISP
assigns are username and myPassword respectively.
Follow these steps to achieve the settings on your DR814Q.
1) On the [Ethernet Port Attachment Setting] page (see Figure 5-2), select the
Attached to PVC1 option from the LAN1 drop-down list to bind LAN1 to PVC1
and bind LAN2 and LAN3 to PVC2 in the same way. Leave the LAN4 default
setting Attached to Router untouched. Click the <Apply> to save your
configuration.
2)
In the [PVC Setting] section, set 0/35 as the VPI/VCI value of PVC1, 0/100 as that
of PVC2.Click <Apply> in the [PVC Setting] section to save your settings. Since
you do not use PVC3 and PVC4 here, there is no need to specify VPI/VCI values
for them.
Figure 5-2 Actual configuration on the Attachment Setting page
3)
Click <Quick Setup> in the navigation bar and select the PPPoE Login option on
the [WAN Connections] page. Set the values of VPI and VCI to 8 and 35
respectively, type userName, myPassword, and myPassword in the PPPoE
Username, PPPoE Password, and PPPoE Password (confirm) text boxes
respectively and then click <Apply> to save your settings.