Installing the daughterboard – HP QMS 1660E User Manual
Page 170
1200x1200
dpi Resolution
Daughterboard
QMS 1660E Print System Reference
6-36
Installing the Daughterboard
M
WARNING!
Turn off the printer and unplug the power cord before
taking the cover off the printer.
ACHTUNG!
Bitte schalten Sie den Drucker aus und ziehen Sie den
Netzstecker heraus bevor Sie die Druckerabdeckung öffnen.
▲
Caution:
Eliminate static by putting on the anti-static wristband
provided with your printer option accessory kit and grounding it to any
base metal surface (such as the bottom of some telephones). Avoid
walking around after grounding yourself because your body may build
up static and you will have to repeat the grounding process.
1
Turn off the printer, and then disconnect the power cord and
all interface cables (parallel, serial, and AppleTalk) from the
printer.
2
Access the printer controller board.
Use the instructions in the “Removing the Printer and Controller
Board Covers” section of this chapter.
3
Attach the daughterboard.
a
Snap the two support posts into the controller board.
b
Position the daughterboard over support posts and the 80-pin
connector.