HP QMS 1660E - Manual (Page 37)

Configuration
Menu
4-5 Printer Configuration
Configuration Menu
The printer’s configuration menu allows you change the default
printer configuration settings. In other words, changes you make
affect all subsequent print jobs.
The options in the configuration menu are organized under three
main menus:
n
Administration Menu
Use this menu to maintain printer-host communication informa-
tion, and for selecting and configuring printer emulations, config-
uring special pages, printing engine calibration, and configuring
hard disks (if installed).
» Note: For information on any of the Administration/
Communications/Network2/CrownNet options (for the Ethernet
interface), see chapter 2, “Printer Configuration,” in the QMS
CrownNet Interface System Administrator’s Guide
.
n Installation Menu
Use this menu to establish passwords for the Operator Control
and Administration menus. This menu displays only when an
optional security card is installed.
n
Operator Control Menu
Use this menu to maintain document processing options (number
of copies, media type, and paper orientation).These capabilities
are usually handled most efficiently within specific print jobs since
each job has its own requirements. However, if there is no way of
specifying these options within a job, you may do so from the
control panel.
Accessing the Configuration Menu
To access the configuration menu, make sure the printer is idle ( IDLE
displays in the message window), then press the Online/Offline key to
take the printer off line (the Online/Offline indicator is not lighted), and
finally press the Menu key.