HP QMS 1660E - Manual (Page 92)

Printer Start-Up
Options
QMS 1660E Print System Reference 4-60
Enabling/Disabling the SYS\START File
If you have a hard disk and Do Sys Start is enabled, when the printer
is turned on, the controller checks the hard disk for a PostScript file
named SYS\START and executes this file. This file does not print.
Loading the PostScript Error Handler
You have the option of loading Error Handler, a diagnostic tool that
allows you to identify PostScript errors encountered during a print job.
Refer to the
PostScript Language Reference Manual (Adobe
Systems Incorporated, Reading, PA: Addison-Wesley, 1990, ISBN 0-
201-18127-4) for more information on PostScript errors.
Choices Yes—Print a start-up page each time the printer is turned on.
No—Don’t print a start-up page each time the printer is turned
on.
Default Yes
Notes If you used the Administration/Engine/Inputbin x Name options
to change the names of the inputbins, these names replace
Multipurpose, Lower, and Optional in the message window.
Menu Administration/Startup Options/Do Sys Start
Choices Yes—Check the hard disk for and execute the SYS\START file
when the printer is turned on.
No—Don’t check the hard disk for a SYS\START file.
Default Yes
Menu Administration/Startup Options/Do Error Handler
Choices Yes—Load the Error Handler.
No—Don’t load the Error Handler.
Default No
Notes You must turn the printer off and on again for this option to take
effect.