HP QMS 1660E - Manual (Page 249)

Supported DOC
Commands
C-3 Document Option Commands
Select original paper size %%IncludeFeature:size
Select pen width and color %%IncludeFeature:pen
Select plotter %%IncludeFeature:plotter
Shift the origin %%IncludeFeature:origin
Reverse image %%IncludeFeature:reverse
HP PCL 5 Emulation Commands
Enable scalable fonts %%IncludeFeature:scalablefonts*
Establish the current resource %%IncludeFeature:install*
and default object ID value
Remove an external object %%IncludeFeature:remove*
%%IncludeFeature:removeresource*
Reset to PCL defaults %%IncludeFeature:reset
Retain temporary macros/fonts %%IncludeFeature:retaintemporary
Select default font
%%IncludeFeature:font*
Select default font ID %%IncludeFeature:fontid*
Select monochrome %%IncludeFeature:monochromegl
Select symbol set %%IncludeFeature:symbolset*
Set carriage return to CR+LF %%IncludeFeature:criscrlf*
Set linefeed to CR+LF %%IncludeFeature:lfiscrlf*
Set number of lines per inch %%IncludeFeature:linesperinch*
Set number of lines per page %%IncludeFeature:linesperpage*
Set point size %%IncludeFeature:pointsize*
Store fonts to disk %%IncludeFeature:resource*
* Indicates a DOC command about which updated information is pro-
vided in the following section, “Updated DOC Commands.”
Lineprinter Emulation Commands
Number lines %%IncludeFeature:number
Retain temporary macros/fonts %%IncludeFeature:retaintemporary
Select font for current job
%%IncludeFeature:font
Set carriage return to CR+LF %%IncludeFeature:criscrlf
Set formfeed to CR+LF %%IncludeFeature:ffiscrlf
Set point size for current job %%IncludeFeature:pointsize
Set linefeed to CR+LF %%IncludeFeature:lfiscrlf
Set margins %%IncludeFeature:lpmargins