HP 958-000290-000 - Manual (Page 33)

edge switch 2/32 installation guide 2-7
Installing and Configuring the Edge Switch 2/32
Verify the type of LAN installation with the customer’s network administrator. If one
switch is installed on a dedicated LAN, network addresses do not require change.
If multiple switches are installed or a public LAN segment is used, network addresses
must be changed to conform to the customer’s LAN addressing scheme. The
following tools are required:
• A maintenance terminal (desktop or notebook PC) with:
— The Microsoft Windows 98, Windows 2000, Windows XP, or Windows
Millennium Edition operating system installed.
— RS-232 serial communication software (such as ProComm Plus or
HyperTerminal) installed. HyperTerminal is provided with Windows
operating systems.
Note that the HAFM server may be used for this function and that HyperTerminal
is included in Windows 2000 provided in the HAFM server as a windows 2000
application.
• An asynchronous RS-232 null modem cable (provided with the switch).
Perform the following steps to change a switch’s IP address, subnet mask, or gateway
address:
1. Remove the protective metal plate from the 9-pin maintenance port at the rear of
the switch (a phillips-tip screwdriver is required). Connect the 9-pin end of the
RS-232 null modem cable to the port.
2. Connect the other cable end to a 9-pin communication port (COM1 or COM2) at
the rear of the maintenance terminal PC.
3. Power on the maintenance terminal. After the PC powers on, the Windows
desktop displays. Refer to operating instructions shipped with the PC.
NOTE: Steps 4 - 13 describe changing network addresses using the HyperTerminal serial
communication software.
4. Choose Start > Programs > Accessories > Communications >HyperTerminal.
The Connection Description dialog box displays, as shown in Figure 2–1 .