Configure fabric operating parameters, Configure fabric operating parameters –29 – HP 958-000290-000 User Manual
Page 55
edge switch 2/32 installation guide
2-29
Installing and Configuring the Edge Switch 2/32
•
Use Open Systems mode for all other (non-FICON) Fibre Channel environments.
Configure Fabric Operating Parameters
Use procedures in this section to set parameters on the switch for fabric operation
through the Configure Fabric Parameters dialog box. These operating parameters
are stored in NV-RAM on the switch.
1. The switch must be offline to change parameters in this dialog box. If it is not and
you activate values, a dialog box displays prompting you to set the unit offline.
CAUTION: Setting the switch offline terminates all Fibre Channel connections.
To set the unit offline:
a.
Choose Maintenance > Set Online State from the Product Manager
window. The Set Online State dialog box displays.
b.
Click Set Offline. A warning box displays asking you to confirm the offline
state.
c.
Click OK.
2. Choose Configure > Operating Parameters > Fabric Parameters from the
Product Manager window. The Configure Fabric Parameters dialog box
displays, as shown in
.