HP 958-000290-000 - Manual (Page 64)

2-38 edge switch 2/32 installation guide
Installing and Configuring the Edge Switch 2/32
• Prohibit or allow connections for an entire row (row 0C is prohibited in the
Configure Addresses—Active dialog box example),
• Prohibit or allow connections for all switch ports,
• Block or unblock all switch ports, or
• Clear connectivity restrictions for all switch ports.
3. At the CUP Name field, type a control unit port description of 24 or fewer
alphanumeric characters (optional). The CUP is an internal switch port that
communicates with channels to report errors and link initialization.
4. Perform one of the following to activate the configuration (without saving it), or
save the configuration for later activation:
• Activate the Configuration—click Activate to activate the configuration
changes (without saving) and close the Configure Addresses — Active dialog
box.
• Save the Configuration—click Save As. The Save Address Configuration
As dialog box displays, as shown in
Figure 2–25 .
Figure 2–25: Save Address Configuration As dialog box
— At the Name field, type a configuration name of 8 or fewer alphanumeric
characters.
— At the Description field, type a configuration description of 24 or fewer
alphanumeric characters.
— Click OK to save the configuration in the address configuration library
and close the Save Address Configuration As dialog box.
— At the Configure Addresses—Active dialog box, click Activate to
activate the configuration and close the dialog box, or click Close to close
the dialog box.