HP 958-000290-000 User Manual
Hp storageworks, Edge switch 2/32 installation guide
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Contents
- About This Guide
- Introduction
- Installing and Configuring the Edge Switch 2/32
- Summary of Installation Tasks
- Table 2-1: Installation Task Summary (Continued)
- Installation Options
- Task 1: Verify Installation Requirements
- Task 2: Unpack, Inspect, and Install the Switch
- Task 3: Configure Network Information
- Task 4: LAN-Connect the Switch
- Task 5: HAFM Server (Optional)
- Task 6: Configure the Switch to the HAFM Application
- Task 7: Record or Verify HAFM Server Restore Information
- Task 8: Verify Switch-to-HAFM Server Communication
- Task 9: Configure Feature Key (Optional)
- Task 10: Configure OSMS or FICON Management Server (Optional)
- Task 11: Set Switch Date and Time
- Task 12: Configure the Edge Switch 2/32 Product Manager Applications
- Configure Switch Identification
- Configuring the Switch
- Configure Fabric Operating Parameters
- Configure Ports (Open Systems Mode)
- Configure Ports (S/390 Mode)
- Configure Port Addresses (S/390 Mode)
- Configure SNMP Trap Message Recipients
- Configure and Enable E-mail Notification
- Configure and Enable Call-Home Features
- Configure Threshold Alerts
- Procedures
- Create New Alert
- Figure 2-29: Configure Threshold Alerts dialog box
- Figure 2-30: New Threshold Alerts dialog box-first screen
- Figure 2-31: New Threshold Alerts dialog box-second screen
- Figure 2-32: New Threshold Alerts dialog box-third screen
- Figure 2-33: New Threshold Alerts dialog box-summary screen
- Figure 2-34: Configure Threshold Alerts dialog box-alerts activated
- Modify an Alert
- Activate or Deactivate Alerts
- Delete Alerts
- Create New Alert
- Task 13: Test Remote Notification (Optional)
- Task 14: Back Up HAFM Configuration Data
- Task 15: Configure the Switch from the Embedded Web Server (Optional)
- Figure 2-37: Username and Password Required dialog box
- Figure 2-38: Embedded Web Server interface-View window
- Configure Switch Ports
- Configure Switch Identification
- Configure Date and Time
- Configure Switch and Fabric Parameters
- Configure Network Information
- Configure SNMP Trap Message Recipients
- Configure User Rights
- Task 16: Cable Fibre Channel Ports
- Task 17: Connect Switch to a Fabric (Optional)
- Task 18: Unpack, Inspect, and Install the Ethernet Hub (Optional)
- Summary of Installation Tasks
- Flexport Upgrade Instructions
- Regulatory Compliance Notices
- Technical Specifications
- Glossary
- Index