HP 958-000290-000 - Manual (Page 44)

2-18 edge switch 2/32 installation guide
Installing and Configuring the Edge Switch 2/32
Configure FMS Feature Key
Perform this procedure to configure the FMS feature key. This feature key enables
host control of the switch from an IBM System/390
or zSeries 900 Parallel Enterprise
server attached to a switch port. The server communicates with the switch through a
FICON channel.
To configure the FMS feature key:
1. Set the switch offline.
2. At the Hardware View page for the selected switch, choose Configure >
Features. The Configure Feature Key dialog box displays, as shown in
Figure 2–12 .
Figure 2–12: Configure Feature Key dialog box
3. Click New. The New Feature Key dialog box displays, as shown in Figure 2–13 .
Figure 2–13: New Feature Key dialog box
4. Type the FMS feature key (case-sensitive xxxx-xxxx-xxxx-xx format) and click
OK. The Enable Feature Key dialog box displays.
5. Click Activate to enable the FMS feature key, as shown in Figure 2–14 . When the
feature key is enabled, the switch performs an IPL and is automatically set to
S/390 operating mode.