HP 958-000290-000 - Manual (Page 74)

2-48 edge switch 2/32 installation guide
Installing and Configuring the Edge Switch 2/32
Figure 2–34: Configure Threshold Alerts dialog box—alerts activated
Modify an Alert
Use the following steps to modify an existing threshold alert configuration.
1. Choose Configure > Threshold Alerts. The Configure Threshold Alerts dialog
box displays.
2. Select the alert that you want to modify by clicking the alert information in the
table.
3. If the alert is active, click Deactivate, then select the alert information in the table
again.
4. Click Modify.
NOTE: If the alert is active, an error message displays prompting you deactivate the alert.
An initial Modify Threshold screen displays where you can change the threshold
type.
5. Choose a threshold type from the drop-down list.