HP 750 - Manual (Page 107)

1 Remove the left endcover ' page 6Ć16.
2 Remove the right endcover ' page 6Ć17.
3 Remove the overdrive assembly ' page 6Ć48.
4 Remove the upper screwfrom the left side plate.
5 Remove the wedge screwand the upper screwfrom the right sideĆplate.
6 Pull the cutterĆenclosure assembly forward and clear of the plotter.
7 To remove the media guides from
the cutter enclosure, grasp each one
firmly, twist it counterĆclockwise,
and pull it clear of the enclosure.
Reassembling: The rear edge of
the cutter enclosure assembly slides
in between the two rear pins on the
left and right sideplates during
replacement.
Upper screw
Upper screw
Wedge screw
Cutter-enclosure assembly
Tx 15
6-55 Removal and Replacement C4705-90000
Removing the CutterĆEnclosure Assembly