Power requirements, Choosing an interface cable – HP 750 User Manual
Page 20
2-2
Site Planning and Requirements
C4705-90000
Power Requirements
HP DesignJet 700, 750C, 750C Plus and 755 CM plotters/printers have selfĆadjusting power
supplies and do not require a voltage selector or switch settings prior to use. The table below
lists the power requirements for the plotters.
Power Requirements
Source Voltage Requirements:
Normal Operating Range:
Frequency:
Voltage
Max current (rms)
100 V ac
1.40 A
120 V ac
1.17 A
220 V ac
0.64 A
240 V ac
0.60 A
90 to 264 V ac
47-63 Hz
Consumption:
140 watts maximum
W A R N I N G
The ac power outlet (mains) must have a protective
earth (ground) terminal. Serious shock hazard leading
to death or injury may result if the plotter is not
properly grounded.
Choosing an Interface Cable
(Instructions ' User's Guide, chapter 1, w Connect the plotter to your computer.)
Serial (RSĆ232ĆC) Interface
A short cable (less than 15 meters or 50 feet) is recommended
for the RSĆ232ĆC interface. A longer cable is permissible, provided the load capacitance does
not exceed 2500 picofarads.
Parallel (BiĆTronics/Centronics) Interface
Use a short cable (less than 2 meters or 6.6 feet)
for the parallel interface.
(Cablepart numbers ' Service Manual, chapter 11.)