HP 750 - Manual (Page 141)

750C
750C
Plus
755
CM
700
Troubleshooting C4705-90000 8-23
3. EEROM Model Type
The purpose of this test is to set the correct plotter model (not applicable to the DesignJet
700). This test also allows you to view (get) which plotter model is currently set.
Set or view the plotter model as follows:
1 In the Service Tests submenu, scroll to 3 EEROM Model type" and press Enter.
SERVICE TESTS
3 EEROM Model type
2 The Get Model type / Set Model type" message is displayed on the frontĆpanel.
3 Press the Up Arrow to view which plotter model is currently set or press the Down
Arrow to set the correct plotter model.
3. EEROM Model Type
The purpose of this test is to view which plotter model is currently set.
View the plotter model as follows:
1 In the Service Tests submenu, scroll to EEROM Model type" and press Enter.
SERVICE TESTS
3 EEROM Model type
2 The DesignJet 700" message is displayed on the frontĆpanel.