Motorola MVME1X7P - Manual (Page 230)

3-32 Computer Group Literature Center Web Site
PCCchip2
3
Transmit PIACK Register
The Transmit PIACK Register is used to execute transmit pseudo interrupt
acknowledge cycles to the CD2401.
When the Local Bus master initiates a read cycle to this register, the
PCCchip2 executes an interrupt acknowledge cycle to the CD2401 with
A7-A0 = $02. (Note that the PILR1 register in the CD2401 should be set
to the same value ($02) for the interrupt acknowledge cycle to operate
properly.)
To finish the local read cycle, the PCCchip2 drives the vector received
from the CD2401 onto the local data bus, and asserts TA*. Reads to this
register are termed pseudo interrupt acknowledge cycles because they are
normal read cycles on the Local Bus side but they are interrupt
acknowledge cycles on the CD2401 side of the PCCchip2. They are
necessary to support polled mode operation with the CD2401.
Note If this register is read when an interrupt is not present, the
interrupt acknowledge cycle times out with a TEA if the Local
Bus timer is enabled.
TIV7-TIV0 Transmit Interrupt vector bits 7-0 reflect the transmit
interrupt vector driven by the CD2401 to the PCCchip2
during a pseudo interrupt acknowledge cycle.
ADR/SIZ $FFF42025 (8 bits)
BIT 23 22 21 20 19 18 17 16
NAME TIV7 TIV6 TIV5 TIV4 TIV3 TIV2 TIV1 TIV0
OPER R R R R R R R R
RESET X X X X X X X X