Maxtor 10K V - Manual (Page 34)

3-10 Maxtor Atlas 10K V
3.4.3 SCA-2 80-Pin Connector Versions
This section describes the SCA-2 (Single Connector Attachment) 80-pin connector
for Maxtor Atlas 10K V drives with the following features:
• SCSI ID
• Spin Up
• Activity LED displays
Use Figure 3-4 to locate the appropriate pins for configuring the drive. Note that
Figure 3-4 does not call out each of the 80 pins on the connector, but rather
illustrates the layout of the pins.
Note: The SCA-2 Connector version of the disk drives does not provide
the following jumper configuration: TERMPWR, Active Termina-
tion, or Write Protection.
3.4.3.1 Termination for the 80-Pin SCA-2 Connector Versions
Note: Refer to your system or SCSI controller documentation regard-
ing any additional recommendations regarding drive placement
on the SCSI bus and SCSI bus termination.
CAUTION: These versions of Maxtor Atlas 10K V disk drives cannot be
configured to provide bus termination. Therefore, be sure to
properly terminate the SCSI bus on which this drive is in-
stalled.