Maxtor 10K V - Manual (Page 4)

Regulatory Statements
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. Any modifications of this device - unless expressly approved by the manufacturer - can void the user’s
authority to operate this equipment under Part 15 of the FCC Rules. Operation is subject to the following two condi-
tions: (1) This device may not cause harmful interference and (2) This device must accept any interference that may
cause undesirable operation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. Howerver, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE: Additional information on the need to interconnect the device with shielded (data) cables or the need for special devices, such
as ferrite beads on cables, is required if such means of interference suppression was used in the qualification test for the device. This
information will vary from device to device and needs to be obtained from the EMC group or product manager.
This Class B digital apparatus complies with Canadian ICES-003.