Maxtor 10K V - Manual (Page 93)

Maxtor Atlas 10K V 5-35
Table 5-49
Initiator-Changeable Mode Pages
NOTE:
1. This page is not supported by the SCSI-1/CCS Operating Mode.
Page Code Page Name Function
Size In
Bytes
00h Unit Attention Control Page
Unit Attention reporting (enables
or
disables)
4
01h
Read-Write Error Recovery Page
Medium Access Error recovery
and
reporting procedures for
READ and WRITE commands
12
02h Disconnect-Reconnect Page
Bus behavior during data trans-
fers
16
07h
1 Verify Error Recovery Page
Medium Access Error recovery
and reporting procedures for the
VERIFY command
12
08h 1 Caching Page Cache policy 20
0Ah 1 Control Mode Page Command processing policy 12
0Ch Notch and Partition Page
Drive geometry
reporting
24
19h Port Control Page Defines port control parameters 8
19h(1h) Margin Control Margin control values 16
19h(2h)
Saved Training
Configuration
Saved training
configuration values
234
19h(3h) Negotiated Settings
Negotiated settings for current
I_T Nexus
14
19h(4h)
Report Transfer
Capabilities
Transfer capabilities 14
1Ah Power Condition Page
Enable and set time intervals for
Idle and Standby modes
12
1Ch 1
Information Exceptions Control Page
and operations of specific information-
al exception
conditions.
Defines methods to control re-
porting
12