Intermec 6710 - Manual (Page 110)

SECTION 4
"
Configuration
4-44 6710 Access Point User’s Guide
[Frame Types] allows filters to be established for common
networking protocols such as IP, Novell IPX, and 802.2 LLC
(Logical Link Control). Separate selections are available for
each of the three Ethernet standards: DIX (Ethernet 2.0),
802.3, and 802.3 SNAP.
A filter may be configured to pass or drop all frames of a
given type. Alternatively, filters may be set to operate on
selected subtypes within each frame type category.
[SubTypes 1] lists several predefined frame types as well as
user-defined frame types. Settings under [SubTypes 2]
allow additional user-defined frame subtypes to be
specified. The default access point configuration passes all
frame types.
[Frame Types]
[Frame Types] options are:
Action Scope
DIX-IP-TCP Ports <Pass> <Unlisted>
DIX-IP-UDP Ports <Pass> <Unlisted>
DIX-IP-Other Protocols <Pass> <Unlisted>
DIX-IPX Sockets <Pass> <Unlisted>
DIX-Other EtherTypes <Pass> <Unlisted>
SNAP-IP-TCP Ports <Pass> <Unlisted>
SNAP-IP-UDP Ports <Pass> <Unlisted>
SNAP-IP-Other Protocols <Pass> <Unlisted>
SNAP-IPX Sockets <Pass> <Unlisted>
SNAP-Other EtherTypes <Pass> <Unlisted>
802.3-IPX Sockets <Pass> <Unlisted>
802.2-IPX Sockets <Pass> <Unlisted>
802.2-Other SAPs <Pass> <Unlisted>