Intermec 6710 - Manual (Page 140)

SECTION 4
"
Configuration
4-74 6710 Access Point User’s Guide
The default is 255.
The retries that occur are also counted by Frag Ack Retry.
Frag QFSK Retry should be smaller than Frag Ack Retry.
900 MHz Options
" NOTE: Appendix C provides additional information about the 900 MHz radio.
Use [Falcon] to set 900 MHz radio options:
File Name ”falcon_d.29k”
Mode-Channel <DS 225K Channel 25>
File Name
File Name is the name of the radio’s driver software. Only
change this name when directed to do so by a Systems
Engineer. Normally, the program’s file name should not be
changed.
Mode- Channel
Mode sets the bit rate option for the 900 MHz radio.
Generally, the higher the bit rate, the lower the range of the
access point. Channel defines a frequency range that is a
small portion of the available bandwidth.
Various communication modes are available, which enable
you to balance the need for radio coverage with the need for
speed. Select the Mode--Channel option to display the list
of mode and channel combinations, which are
country-dependent.