Intermec 6710 - Manual (Page 179)

SECTION 5
"
Software Download
6710 Access Point User’s Guide 5-19
As long as the StartTime has not counted to zero on its own,
the timer stops and the software download process halts.
When the timer does count down to zero, it uses the
ServerIpAddress value and the ScriptFilename value to get
the script file. If either of these is not set, an error is noted
in the status variable and the software download process is
aborted.
The variable’s format is:
File>
sdvars set starttime <dd:hh:mm:ss>
EXAMPLE: This command line sets the download start time to begin in 5
minutes:
File> sdvars set starttime 00:00:05:00
Status
Status is a read-only variable set by the software download
mechanism to indicate whether the download completed
successfully.
CheckPoint
CheckPoint is a numeric variable that is used to check on
the progress of an active download in an access point. By
setting CheckPoint to a different value after each command
in the script file, you can read the value to determine how
far the access point progressed through the script file. You
can also test for failure if a script file aborts. The variable’s
format is:
File>
sdvars set checkpoint <value>
For example, consider the following script file commands: