Intermec 6710 - Manual (Page 159)

SECTION 4
"
Configuration
6710 Access Point User’s Guide 4-93
Table 4-1 (Continued)
Configuration Guide
z = required step; Z = recommended step
Simple Network Advanced Functions
2. Preliminary Configuration Before
Installation (Through DIAG Port):
Z
Set LAN ID to a nonzero value
(page 4-23).
z
Configure access points with IP
address configuration (page 4-16) or
DHCP server name (page 4-20).
z
OWL/IP: Configure IP addresses
in access points serving as super
root candidates or OWL/IP desig-
nated bridge candidates.
DHCP may not be used to assign
addresses to these access points
unless a permanent lease is
assigned, and the access points
are rebooted prior to configuring
OWL/IP.
Z
Configure the Ethernet port cable
type (page 4-42).
Z
For the open wireless LAN frame
Z
For the open wireless LAN frame
type, use DIX (the default) (page
4-41).
z
Configure the root priority in super
root candidates to specify primary
and fallback access points. Set all
other access points to root priority 0.
(Page 4-24.)
z
Set the highest root priority in
the primary super root, and lower
root priorities in no more than
two fallback super roots (page
4-24).
z
Secondary LANs or wireless
access point: If using WLIF
(2.4 GHz) radios, configure the
Slave radio setup in wireless
access points or secondary LAN
designated bridges (page 4-61).