Intermec 6710 - Manual (Page 198)

SECTION 6
"
Indicator Lights
6-6 6710 Access Point User’s Guide
PCMCIA Lights
PCMCIA indicator lights show the status of the two PC
card slots, which are labeled NIC1 and NIC2. The left light
shows the status of NIC1; the right light shows the status
of NIC2. Table 6-5 shows light indications for both ports.
Table 6-5
PCMCIA Indicator Lights
Status Indication
OFF A functional or enabled radio is not installed in the
slot.
ON A functional and enabled radio is installed in the slot.
BLINK Installed radio is active and has communicated with
a wireless station in the past 10 minutes.
When the access point reboots in ROM mode, the R-LINK,
W-LINK, NIC1, and NIC2 indicator lights show — for about
nine seconds — the DIAG port’s baud rate. The lights show
the status about eight seconds after the W-LINK light stops
blinking. Table 6-6 shows baud rates.
Table 6-6
DIAG Port Baud Rates, ROM Mode
R-LINK W-LINK NIC1 NIC2 Baud Rate
OFF OFF OFF ON 2400
OFF OFF ON OFF 4800
OFF OFF ON ON 9600
OFF ON OFF OFF 14400
OFF ON OFF ON 19200
OFF ON ON OFF 28800
OFF ON ON ON 38400
ON OFF OFF OFF 57600