Intermec 6710 - Manual (Page 240)

APPENDIX E
"
OWL/IP
E-18 6710 Access Point User’s Guide
Alternatively, if a limited set of known applications is to be
supported, filters may be set to selectively pass listed Port
numbers. Following is the [Frame Types] screen:
Action Scope
DIX-IP-TCP Ports <Drop> <Unlisted>
DIX-IP-UDP Ports <Drop> <Unlisted>
For example, to support FTP (data and control) and Telnet,
enable protocol ports 20, 21, and 23, respectively.
The above IP port numbers are specified as decimal values.
These can be input directly by following the entry with a
decimal point; for example, “20.” Values are displayed in
the table as hexadecimal values: 14, 15, and 17.
Following is the [SubTypes 1] screen:
Action SubType Value
DIX-ARP <Pass> <DIX-EtherType> 08 06
SNAP-ARP <Drop> <SNAP-EtherType> 08 06
802.2-IPX-RIP <Drop> <802.2-IPX-Socket> 04 51
802.2-IPX-SAP <Drop> <802.2-IPX-Socket> 04 53
NNL <Pass> <DIX-EtherType> 87 5b
NETBIOS <Drop> <802.2-SAP> f0 f0
1 <Pass> <DIX-IP-Protocol> 00 01
2 <Pass> <DIX-IP-TCP-Port> 00 14
3 <Pass> <DIX-IP-TCP-Port> 00 15
4 <Pass> <DIX-IP-TCP-Port> 00 17
.
.
16
<Drop> <DIX-IP-TCP-Port> 00 00