Intermec 6710 - Manual (Page 98)

SECTION 4
"
Configuration
4-32 6710 Access Point User’s Guide
2. Does the network contain only 900 MHz or S-UHF
access points?
Answer Settings
Yes Inbound/Unicast/Disabled
Outbound to Secondaries/Unicast/Disabled
Comments:
Unicast flooding is never required for 900 MHz or
S-UHF access points, since stations supporting these
media options establish reliable connections as they
roam between access points. The correct port for
S-UHF or 900 MHz stations is always known.
3. Do all nodes in the radio network routinely transmit a
frame at least once every 4 minutes?
Answer Settings
Yes Inbound/Unicast/Disabled
Outbound to Secondaries/Unicast/Disabled
4. Do any nodes in the radio network need to receive
multicast or broadcast messages?
Answer Settings
No Inbound/Multicast/Enabled
Outbound to Secondaries/Multicast/Disabled
Note: TCP/IP nodes must receive broadcast ARP frames.
Comments:
The destination of a multicast frame is never known.
The Disabled setting should be used for any network
where stations do not need to receive multicast
frames. The Disabled setting can be used for
secondary LANs that only need to receive ARP frames.
When WLIF wireless stations must receive multicast
frames, set Outbound to Stations to Enabled.