Intermec 6710 - Manual (Page 53)

SECTION 3
"
Installation
6710 Access Point User’s Guide 3-9
Vertical and Ceiling Mounts
See Figure 3-6 and the procedure following it.
" NOTE: If mounting the access point on a hollow wall, secure the mounting
plate to a 3/4” (thick) plywood base by four 1” X 1/4” nuts, bolts, and
washers. Anchor the plywood base to two separate wall studs by
four 2” X 1/4” diameter lag screws (two lag screws in each stud).
Figure 3-6
Mounting Bracket
6.00"
1.00"
2.00"
1.00"
1.00"
2.00”