JVC VR-N1600E - Manual (Page 111)

103
E mail Settings
Memo :
● You can send a test e-mail by clicking the [Test] button. If
the e-mail address of the sender is not registered with the
mail server of the recipient, the [The mail address of the
sender is not valid. ...] message may appear. When this
occurs, double-check the sender’s e-mail address and
outgoing mail server, and re-enter the e-mail address.
● E-mail messages are sent in the following cases.
● When an input event occurs
(APage 92 [Specifying an Input Event])
● When the event button is clicked
(APage 95 [Configuring Event Buttons])
● When a generic event occurs
(APage 96 [Specifying Generic Events])
● When motion is detected
(APage 100 [Specifying Motion Detection.])
● When camera failure occurs
● When an archiving error occurs
(APage 104 [Archiving])
● In order to send an e-mail, you need to specify the timing
for sending out e-mails in [Scheduler Setting] (A Page
49).
● After you have completed the e-mail setting, perform a
test to verify that it can be sent successfully.
A
B
C
D
E
G
F
[E-mal setup] Screen
Item Description
A Enable E-
mail(Monitor) Select this check box to enable sending
of e-mail alerts.
B Recipient(S) For specifying the e-mail addresses to
send alerts to. If you are specifying more
than one e-mail address, separate the e-
mail addresses using semicolons.
C Sender
Settings For specifying the sender’s e-mail
address, outgoing (SMTP) mail server
name and login settings.
D Subject text For specifying the mail title.
E Message text For specifying the message text.
F Time
btw.mail(min
utes) For specifying the time interval (minutes)
for sending each e-mail alert.
G Include
Image Select this check box to include images
in the message.
VR-N1600_J.book Page 103 Tuesday, June 3, 2008 2:26 PM