JVC VR-N1600E - Manual (Page 117)

109
This section enables you to assign an IP address to each
camera and configure various auto detect settings.
Specifying IP Lease
For configuring the function to assign IP addresses to each
network camera.
Note :
● In order to assign an IP address of the network camera
using the IP Lease feature, you need to enable the DHCP
of the network camera. For procedures to enable the
DHCP of the network camera, refer to the instruction
manual of the network camera.
1
Select [Auto Detect Setting] from [Main Menu]
● The [Auto Detect Settings] screen appears.
2
Select [Enable] in [IP Lease]
Memo :
● If a network uses a multiple number of NVR units, enable
the [IP Lease] only for one unit. Select [Disable] if a
DHCP server is operating on the same network.
● When the [IP Lease] is enabled for two or more devices at
the same time, the IP address may change to a static
address, and cause malfunction of the cameras.
3
Specify the following items under [IP Lease
Parameter]
4
Click [OK]
● Doing so hides the setting screen and starts IP Lease.
● Select ADisableB in Step 2
to stop IP Lease.
Auto Detect Settings
2
3
4
[Auto Detect Settings] Screen
Item Description
Start Address For specifying the first IP address to be
assigned to the cameras.
Unit For selecting the number of IP
addresses to be assigned to the
cameras. The selected number of IP
addresses will be assigned starting from
the first IP address.
Subnet Mask For specifying the subnet mask for the
cameras.
Default Gateway For specifying the gateway for the
cameras.
DNS Server For specifying the DNS server address
for the camera(s).
Domain Name For specifying the domain name for the
cameras.
Lease Time Limit For specifying the valid period of the IP
address assigned to the cameras. If
AYesB is selected, you can set the lease
time in units of hours.
Client For selecting whether to apply
restrictions on the device when
assigning the IP address. If
AOnly
Camera B is selected, IP address will
only be assigned to the corresponding
camera. If
AAny ClientB is selected, IP
address will be assigned to all devices.
Reserve MAC
Address Configure the [Reserve MAC Address] if
you want to assign a specific IP address
to the cameras. A specific IP address is
always mapped to a MAC address.
Enter a value in the MAC and IP fields,
and click [Add] to set the addresses. To
cancel the setting, select a displayed
MAC and IP address, and click [Del].
VR-N1600_J.book Page 109 Tuesday, June 3, 2008 2:26 PM