JVC VR-N1600E - Manual (Page 99)

91
The input/output port is the input/output terminal that is found on
each device registered with this unit. You can register the input
port as [Input events], and the output port as [Outputs...].
A registered input/output port can be linked to an event as
described below. (APage 98 [Specifying an Output Port])
● Events can be used to start recording, send e-mails, move
the PTZ camera to a preset position, and control the
output port of the device. Events are divided into the four
types as described below.
I/O Settings
1
Click the [I/O Setup...] button on the [Camera
Record Setting] screen
● The [I/O Setup] screen appears.
● The [I/O Setup] screen enables you to add input
events, VMD events and outputs that can be used by
the network cameras.
Note :
● The available events differ among network cameras.
● When an event is defined using the [I/O Setup] screen,
this automatically overwrites the alarm settings at the
camera. If a generic event is already in use (when the
alarm settings at the camera are configured manually),
the generic event or the event audio that makes use of the
generic event (A Page 124) will be disabled. However,
the generic event settings at the recorder unit remain
unchanged. (VR-N1600U/E)
Camera Input/Output Port
and Events
Input events Registers input signals of sensors
connected to the input port of the device
as an [Input events].
Generic events Registers as a generic event.
VMD events Registers the detected image motion as a
VMD (Video Motion Detection) event.
Event buttons Event generated by buttons that enable
manual operation.
A
B
C F
E
D
[I/O Setup] Screen
Item Description
A Add new
event... For specifying input events for the
device selected in the [Defined events]
list. You may be able to specify multiple
input events for some devices.
Click the [
] mark next to the device
in the [Defined events] list, select the
preset input event, and click the [Add
new event...] button to specify a timer
event. (A Page 93)
B Add new
output event... Displays the [Add new output] screen.
(A Page 94)
C Add VMD
Event(Motion
Detection) For specifying a VMD (Video Motion
Detection) event for the device selected
in the [Defined events] list. Only one
VMD event can be defined for each
camera.
Note :
● To avoid the risk of generating an
excessive number of VMD events,
a new VMD event cannot occur
within five seconds after the
occurrence of the last VMD event.
● VMD events cannot be sent by e-
mail.
D Advanced... Displays the [Advanced...] screen.
(A Page 94)
E Remove
selected For deleting the event selected in the
[Defined events] list.
F Edit
selected... For editing the event selected in the
[Defined events] list.
VR-N1600_J.book Page 91 Tuesday, June 3, 2008 2:26 PM