JVC VR-N1600E - Manual (Page 33)

25
You can switch the resolution of the VGA output using the
following procedures.
● Press and hold the [FUNCTION] button, and press the
[14/ZOOM OUT](ZOOM OUT/CANCEL) button at the
same time.
`
BPressing the button each time increases the resolution
value.
● Press and hold the [FUNCTION] button, and press the
[15/ZOOM IN](ZOOM IN/ENTER) button at the same
time.
`
BPressing the button each time decreases the resolution
value.
Memo :
● Selecting a resolution not supported by the monitor may
prevent normal monitor synchronization.
Note that any incorrect changes made to the settings of this unit
may cause it to malfunction.
Before making any changes, save the current settings to [Flash
Memory Utility] (A Page 107) to allow you to restore the
previous settings should anything go wrong.
It is recommended that you save the setting data before making
any changes.
Changing Monitor
Resolution
Preset
Values : 1024 x 768 (Default value)
1280 x 768
1280 x 1024
1600x1200
OPERATE
REC CONTROL
LIVE/BROWSE
SELECT
PTZ/PRESET
SERIAL
㧝 㧞 㧟 㧠
㧡 㧢*1/' 㧣
㧥  
㧤

   
CANCEL ZOOM OUT ZOOM IN ENTER
WARNING
ALARM
HDD
LOCK
SEARCH FUNCTION ALARM CLEAR KEY REC/STOP STOP(PB) PLAY
SKIP
REV FWD
VR-N900U
VR-N1600U/E
[15/ZOOM IN] Button
[FUNCTION] Button [14/ZOOM OUT]
Button
[ZOOM IN/ENTER] Button
[FUNCTION] Button
[ZOOM OUT/
CANCEL] Button
Precautions when
Changing Settings
VR-N1600_J.book Page 25 Tuesday, June 3, 2008 2:26 PM