JVC VR-N1600E - Manual (Page 27)

19
Selecting a language
The [Language Setting] screen appears when you start up this
unit for the first time. Select the language to use using the steps
below.
1
Select a language
● Use the [2/D] or [10/0/E](8/E) button to select a
language. `
2
Use the [SKIP] button to select [OK], followed by
pressing the [16/ENTER](ZOOM IN/ENTER)
button
`
● The AThe system is being set up.B message may
appear depending on the setting, and the system is
automatically rebooted.
Memo :
● Selecting [OK] changes the color of the [OK] characters
from brown to orange.
Automatic Registration of Cameras
After you have started up this unit for the first time and finished
selecting a language, the [Auto Detect] screen appears.
1
Check to ensure that [Auto Detect] is selected,
followed by pressing the [16/ENTER](ZOOM IN/
ENTER) button
`
● The APlease wait...B message appears.
Memo :
● The characters of the selected item switches to orange
color.
Memo :
● In the case of VR-N900U, the analog input appears on the
[Auto Detect] screen from the start as the AAnalog-inB
network encoder (IP video server) of A192.168.201.12B.
2
Check to ensure that the camera is detected
● After the message disappears, a list of detected
cameras is displayed.
● If all the cameras are not detected, press the [Auto
Detect] button again. If doing so does not solve the
problem, check the connection with the cameras and
the IP address of the cameras.
3
Replace the detected camera accordingly in
sequence
Use the [SKIP] button to select the Sort button, followed by
pressing the [16/ENTER](ZOOM IN/ENTER) button to sort the
order of the detected cameras in sequence.
`
● The Sort button allows you to perform [IP] sort, [MAC]
sort, [CH] sort, [MAKER] sort, or [MODEL] sort.
● After using the [SKIP] button to select the list, followed
by using [2/D] or [10/0/E](8/E) to select a camera, use
the [SKIP] button to select [Up] or [Down], and press
the [16/ENTER](ZOOM IN/ENTER) button to change
the sequence of the cameras.
`
● Deselect the check box of any camera that you are not
using.
Note :
● Do not remove the check for Analog-In. (VR-N900U)
Memo :
● Priority is given to cameras at the top of the list during
use, and camera numbers will be registered in sequence
from the top.
4
Use the [SKIP] button to select [Entry], followed
by pressing the [16/ENTER](ZOOM IN/ENTER)
button
`
● The camera that is automatically detected is registered
in the system.
5
Select the analog input channel and signal
format to be used (VR-N900U)
5
NR-N900U
VR-N1600_J.book Page 19 Tuesday, June 3, 2008 2:26 PM