JVC VR-N1600E - Manual (Page 26)

18
Getting Started
VR-N1600 is equipped with an operation lock feature to prevent
the system from being turned off accidentally as well as
unauthorized recording operations.
Setting Operation Lock
1
Press and hold the [FUNCTION] button, and press the
[KEY] button at the same time
● Operation is locked. The [LOCK] indicator lights up
when in the operation lock mode.
Canceling Operation Lock
1
(When in the operation lock mode) Press the
[KEY] button while holding down the
[FUNCTION] button
● Operation lock is canceled.
● The light of the [LOCK] indicator goes off.
Perform language setting and automatic camera registration
when starting up this unit for the first time.
Starting the VR-N1600 unit
1
Turn on the power switch at the rear panel.
● Doing so starts up the VR-N1600 unit.
Operation Lock
OPERATE
REC CONTROL
LIVE/BROWSE
SELECT
PTZ/PRESET
SERIAL
㧝 㧞 㧟 㧠
㧡 㧢*1/' 㧣
㧥  
㧤

   
CANCEL ZOOM OUT ZOOM IN ENTER
WARNING
ALARM
HDD
LOCK
SEARCH FUNCTION ALARM CLEAR KEY REC/STOP STOP(PB) PLAY
SKIP
REV FWD
[FUNCTION]
[KEY] Button
[LOCK]
During Initial Startup
Before Starting Up.
● The DHCP setting is required for the IP camera
beforehand. Start up this unit first, then switch the
camera on after confirming that the [Auto Detect
Setting] window is displayed.
● Refer to the user manual supplied with the camera for
instructions on how to specify the IP camera settings.
● By default, Time zone is set to GMT. Specify a Time
zone according to the region used. Refer to the
INSTRUCTIONS on how to specify a Time zone
settings.
OPERATE
REC CONTROL
LIVE/BROWSE
SELECT
PTZ/PRESET
SERIAL
㧝 㧞 㧟 㧠
㧡 㧢*1/' 㧣
㧥  
㧤

   
CANCEL ZOOM OUT ZOOM IN ENTER
WARNING
ALARM
HDD
LOCK
SEARCH FUNCTION ALARM CLEAR KEY REC/STOP STOP(PB) PLAY
SKIP
REV FWD
VR-N1600U/E
VR-N900U
Keypad
[SKIP] Button [KEY] Button [16/ENTER] Button
Keypad
[SKIP] Button [KEY] Button [ZOOM IN/ENTER]
Button
VR-N1600_J.book Page 18 Tuesday, June 3, 2008 2:26 PM