Speco Technologies DVR-16TS - Manual (Page 103)

User’s Manual
DVR-4TN/8TN/16TN/16TS/16TT Series
SPECO TECHNOLOGIES 01/08
102
5.8 Configuration
The Configuration menu can be used to restore the default factory settings,
import and export configurations. Select <Configuration> from the Main menu
and press ENTER. The following menu is displayed.
Configuration
1. Load Factory Default
2. Import Config
3. Export Config NO
Items in this menu are described in the following subsections.
5.8.1 Load Factory Default
This item is used to load the factory default setting; select <YES> to recall the
factory default setup configuration from the “read-only” memory, or <NO> to
cancel.
5.8.2 Import Configuration
This item allows the user to load a unit configuration that was saved on an
external drive. To import a configuration that was previously exported, make
sure the device that saved the configuration is connected to the unit. Select
<Import Config> from the Configuration menu and press ENTER. The
following menu is displayed.
Import Config
Config Name
xxxx-xxxx
xxx-xx Select
NO
NO
Press UP / DOWN to select one of the available listed configuration files, and
choose <YES> to start to import.
NOTE:
If the imported configuration has a different record mode from
the unit’s, the warning message “This config has different record mode.
This will FORMAT ALL HARDDISKS.” will show.
NOTE: Remove the ThumbDrive
®
used for importing
configuration after the unit restarts, or it will be formatted as well
.