Speco Technologies DVR-16TS - Manual (Page 38)

User’s Manual
DVR-4TN/8TN/16TN/16TS/16TT Series
SPECO TECHNOLOGIES 01/08 37
4.2 Sequence Setup
This section introduce you how to view in sequence mode with both Main
Monitor and Call Monitor, if connected. Sequence function can avoid manually
backtracking and give more flexibility while surveillance.
4.2.1 Sequence on Main Monitor
The automatic sequence function can be used in any view mode. Select
certain view format and press SEQ to toggle the automatic sequential
sequence, press ESC to stop sequencing. The figure below displays the
4-camera sequencing view modes.
4.2.2 Call Monitor Control
Users can use the DVR-4TN/ 8TN/ 16TN/ 16TS/ 16TT series unit front panel
to control a call monitor display without having to access the Main menu. Two
viewing modes can be displayed on call monitor: Sequence display and
Single camera display. To program the call monitor sequence, see section 5.5
Sequence Setup.
Follow the steps below to control the call monitor.
• Press the CALL key on the front panel to enter call monitor control mode,
the message “Call Mode” will then be shown on the bottom-left of the
screen.
Press 1-16 Key To Select Channel
Press SEQ To Enable Sequence
Call Mode
• Press CHANNEL key to display the associated camera on the call monitor.
• Alternatively, press SEQ repeatedly to display the sequence of cameras
previously programmed in Call Monitor Schedule menu.
• Press ESC to return to the front panel to the Main monitor control mode.