Speco Technologies DVR-16TS - Manual (Page 70)

User’s Manual
DVR-4TN/8TN/16TN/16TS/16TT Series
SPECO TECHNOLOGIES 01/08 69
NOTE:
The Server IP and the Client IP must not be identified as the
same IP address; but they have to be set in the same domain.
For example: Server IP: 192.168.0.1
Client IP: 192.168.0.2
Dial-in Password
This item allows the user to setup the Dial-in password. Follow these steps to
setup the login password.
• Select <Dial-in password> from Dial-in Setup menu and press ENTER. A
virtual keyboard displays.
• Use Direction keys to select character.
• Press ENTER to add the selected character to the password entry field.
• When done, move the cursor to <OK> and press ENTER to save the
settings and exit.
Server IP
This item is for setting the IP address that identifies the DVR-4TN/ 8TN/ 16TN/
16TS/ 16TT series unit over a modem connection. To set the server IP, follow
these steps:
• Select <Server IP>.
• Using LEFT/ RIGHT to move the cursor over the IP, and stop where you
want to make the change.
• Press ENTER, and then use UP/ DOWN to change the value.
• When done, press ENTER again to exit.
• Repeat the procedure until the IP is completely set.
Client IP
This item determines the remote PC’s IP address for connecting with the
DVR-4TN/ 8TN/ 16TN/ 16TS/ 16TT
series unit. To set the Client IP, follow
these steps:
• Select <Client IP>.
• Using LEFT/ RIGHT to move the cursor over the IP, and stop where you
want to make the change.
• Press ENTER, then use UP/ DOWN to change the value.
• When done, press ENTER again to exit.
• Repeat the procedure until the IP is set completely.