4 detection config – Speco Technologies DVR-16TS User Manual
Page 98
User’s Manual
DVR-4TN/8TN/16TN/16TS/16TT Series
SPECO TECHNOLOGIES 01/08
97
5.6.7.4
Detection Config
If motion detection function is enabled, it is required to define the motion
detection parameters such as detection area and sensitivity settings. Select a
channel for setting the parameters, move the cursor to <Detection Config>,
and press ENTER. The Detection Configuration menu displays as follows.
Detection Config
1. Detected Area Setup
2. Sensitivity
3. Area Threshold
88%
6%
----- Detected Area Percentage -----
40%
▲
Detected
Area
Setup
The Detect Area is displayed as follows after selecting this item. The detection
area consists of 273 (21×13) detection grids in NTSC video format or 336
(21×16) grids in PAL format.
■
■
■
■
■ ■ ■ ■
■
■
■
■
■
■
■
■ ■
■
■
■
■
■
■
■
■
■
■
Use the Direction keys to move the cursor and press ENTER to enable or
disable a grid. Press MODE to select all of the grids for detection; press
MODE again to de-select all of the grids.
Sensitivity
This item is used to set the sensitivity of detection grids for the camera. A
greater value indicates more sensitive motion detection. A motion alarm will
be triggered, once the amount of motion detected exceeds the Threshold
value
Move the cursor to <Sensitivity> and press ENTER, and then use UP / DOWN
keys to adjust the value. The value is indicated in 4% increment.