Schneider Electric Modbus Plus Network Bridge Multiplexer none - Manual (Page 54)

Configuring the Modbus Models 31007492 44
3.7 Your Configuration Screens
You have four configuration screens:
V1
Use this screen to display and set the communication parameters for
each port.
V2
Use this screen to display and set locations 1 ... 32 of the Modbus
Address Map table for each port.
V3
Use this screen to display and set locations 33 ... 64 of the Modbus
Address Map table for each port.
V4
Use this screen to Save or Initialize the BM85 configuration.
Help Screens: V5, V6, V7, V8
You have four Help screens that you can access during configuration.
You can select the Help screens by selecting screens V5, V6, V7, or V8.
Pressing the `question mark` ( ? ) key will display Help for the
configuration screen you are currently using.
3.7.1 Entering Commands Into Your Screens
When the BM85 is initially powered up for configuration, the V1 screen
is shown for port 1. You can begin entering the port 1 parameters
immediately.
The currently active port is always shown at the bottom line of your
screen.
To select another screen for the active port, enter commands V1, V2, V3,
or V4. To select another port, enter commands P1, P2, P3, or P4.
When you enter the configuration commands, you can enter them singly
or as a string. Press ENTER to complete the entry. To correct
keystrokes in an entry, press DELETE. To cancel an entry before
completing it, press ESCAPE.