Sanyo DSR-5716P - Manual (Page 74)

INITIAL SET 1
English
73
The above examples are set as follows.
<TIME PERIOD SET> screen
z
TIME PERIOD A
T-1=6:00, T-2=13:00, T-3=20:00, T-4=00:00
z TIME PERIOD B
T-1=6:00, T-2=11:00, T-3=13:00, T-4=00:00
z SEQUENCE
“TIME PERIOD A”
z MASK
“TIME PERIOD B”
<MAIN/MON.2 MONITOR SET> screen
z
T-1
All “OFF”
z T-2
“OFF” except cameras No. 1, 5, 9 and 12
z T-3
“OFF” except cameras No. 1, 8 and 16
<MASK SET> screen
z
T-1
“ON” for cameras No. 2, 4, 5, 7, 10 and 16.
z T-2
“ON” for cameras No. 1, 4, 6, 11, 12, 13 and 14.
z T-3
All “OFF”
The following menu settings must be made to enable
operation of the time periods. After completing these settings,
be sure to then carry out the timer setting.
„ Setting automatic selection of camera video
Select the camera to be automatically selected to display
video and set the switching interval.
To do this, set “SEQUENCE SET” from the <SCREEN SET>
screen. (JP.134)
„ Masking camera video using a gray pattern
Use “MASK” from the <SCREEN SET> screen to specify
which cameras are to be displayed on the monitor and which
are not. (JP.136)
„ Alarm recording using motion sensors
Set “MOTION SENSOR” from the <ALARM REC MODE
SET> screen. (JP.105)
Operations during the specified time periods
<SCREEN SET>
1.MULTI SCREEN : NORMAL
QUAD POSITION SET ->
MULTI 9 POSITION SET ->
MULTI 16 POSITION SET ->
2.SEQUENCE SET
FULL : 1S QUAD : 1S
MAIN/MON.2 MONITOR SET ->
3.MASK : OFF
MASK SET ->
4.COLOR LEVEL SET ->
<SCREEN SET>
1.MULTI SCREEN : NORMAL
QUAD POSITION SET ->
MULTI 9 POSITION SET ->
MULTI 16 POSITION SET ->
2.SEQUENCE SET
FULL : 1S QUAD : 1S
MAIN/MON.2 MONITOR SET ->
3.MASK : OFF
MASK SET ->
4.COLOR LEVEL SET ->
<ALARM REC MODE SET>
ALARM RECORDING : OFF
PICTURE QUALITY : ENHANCED
PICTURE QUALITY SET ->
AUDIO RECORDING : OFF
ALARM INTERLEAVE : ONLY
REC RATE: 15FPS, DURATION: 20SEC
PRE-ALARM RECORDING : ***
REC RATE: ***** FPS, DURATION: *****
ALARM TRIGGER : ALARM
MOTION SENSOR ->