F118 - option board configuration, F118 – option board configuration, Rs, see – Symmetricom XLi IEEE 1588 User Manual
Page 116: F118 – option board, Command line, F118<s>b<n><cr><lf
108
XLi IEEE 1588 Clock
997-01510-03, Rev. C, 12/12/2006
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
1
F118 – Option Board Configuration
Note: The standard XLI IEEE 1588 Clock includes a
and an
. Other option cards are currently unsupported for the standard XLI IEEE 1588 clock.
Use function F118 to query the XLi for the option bay location of CPU-aware cards. The following figure
shows the position of the option bays as seen when viewing the XLi from the rear.
Figure 6: Option bay locations
The cards recognized by F118 are as follows:
•
N.1 Frequency Synthesizer (87-8022)
•
N.8 Frequency Synthesizer (86-708-1)
•
GPS Receiver (86-8013)
•
•
Frequency and Time Deviation Monitor (87-8023)
•
Have Quick/1 PPS Time and Frequency Reference (87-8016-3)
•
Have Quick Out (87-8016-6)
The cards not recognized by F118 are as follows:
•
Multicode Output (87-6002-XL1)
•
Low Phase Noise 5 MHz Output (87-8009-5)
•
Low Phase Noise 10 MHz Output (87-8009-10)
•
Enhanced Low Phase Noise 10 MHz Output (87-8040)
•
1, 5, 10 MHz Sine/MPPS Square Output (86-8008)
•
T1 Telecom Interface Output (87-6000T1-8)
•
E1 Telecom Interface Output (87-6000E1-6)
Command Line
To display the XLi option bay information, enter the following command:
F118<S>B<N><CR><LF>