F51 - gps antenna cable delay, F51 – gps antenna cable delay, Xli responds – Symmetricom XLi IEEE 1588 User Manual
Page 63: Xli responds using the following format, Where: for example, F50<s>b<n><sep>xyz<cr, F50 b1 xyz<cr
XLi IEEE 1588 Clock
55
997-01510-03, Rev. C, 12/12/2006
2
5
1
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
XLi responds:
F50 B1 N 38d23'51.3" W 122d42'53.2" 58m<CR><LF>
To display the present antenna position using ECEF XYZ coordinates in meters, use the following
format:
F50<S>B<N><SEP>XYZ<CR>
XLi responds using the following format:
F50B<N><S><SIGN><S><MX>m<S><SIGN><S><MY>m<S><SIGN><MZ>m<CR><LF>
where:
For example:
F50 B1 XYZ<CR>
XLi responds:
F50 B1 X –4474331m Y 2668899m Z –3668099m<CR><LF>
F51 – GPS Antenna Cable Delay
Use function F51 to display or configure the GPS antenna cable delay. Setting a positive value for F51
compensates for the time the signal takes to travel the length of the cable from the GPS antenna to the
receiver. When multiple GPS receivers are installed, a separate value can be set for each unique
receiver. The factory setting for F51 is +60 ns, which corresponds to the 50-foot (15.24-meter) long RG-
F
= ASCII character F
50
= function
number
<S>
= ASCII
space
character
B
= ASCII letter to denote Option Bay number follows
<N>
= Option Bay Number, 1 through 4.
<SIGN>
= Either + or - for the position of the ECEF XYZ coordinates
<MX>
= Antenna X-position in meters to tenths of a meter
<MY>
= Antenna Y-position in meters to tenths of a meter
<MZ>
= Antenna Z-position in meters to tenths of a meter
m
= ASCII character m for Meters
<ALT>
= altitude in meters
<CR>
= carriage return character
<LF>
= line feed character