F100 bh - burn host, F100 bub - burn bootloader, F100 bh – burn host f100 bub – burn bootloader – Symmetricom XLi IEEE 1588 User Manual
Page 97: F100 bh – burn host, F100 bub – burn bootloader, Where: an example of the response is, The xli responds, Burn host is ready!!!<cr><lf
XLi IEEE 1588 Clock
89
997-01510-03, Rev. C, 12/12/2006
2
5
1
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
where:
An example of the response is:
F100 ST FLASH/CRC : PASS, RAM : PASS, SERIAL : PASS, NVRAM VER : PASS<CR><LF>
F100 BH – Burn Host
Use function F100 BH, when upgrading firmware, to select the FTP host and the file to be transferred.
To select the FTP host and file for upgrading, enter:
F100 BH <FTP HOST IP ADDRESS><S><UPGRADE FILE PATH>/<FILE NAME><CR>
Use UNIX style forward slashes ‘/’ in path and leave the drive letter (e.g., ‘C’) out of the path.
For example:
F100 BH 10.1.7.20 truetime/xli/192-8001.bin<CR>
The XLi responds:
BURN HOST IS READY!!!<CR><LF>
F100 BUB – Burn BootLoader
Note:
See “B: Upgrading System Firmware” on page 145.
When upgrading the system firmware, use function F100 BUB to burn the BootLoader, to write the
BootLoader to flash memory.
F
= ASCII character F
100
= Unit function number
<S>
= Space
ST
= Specify
ST
command
FLASH/CRC:
= Specify flash checksum result
RAM:
= Specify RAM test result
SERIAL:
= Specify Serial Port test result.
NVRAM VER:
= Specify version test result. This test compares the version of the code against the version
recorded in Non-Volatile memory
<STATUS>
= Is either ASCII PASS or FAIL
,
= ASCII
comma
:
= ASCII
colon
<CR><LF>
= Output
line
terminator