Request the ptp subdomain name, Set the ptp subdomain name, Where: for example, enter – Symmetricom XLi IEEE 1588 User Manual
Page 138: Response (one of the following lines), For example, enter, Response (example), F131 b<n> sdn<cr, F131 b4 sdn, F131 b4 sdn _dflt <cr><lf
130
XLi IEEE 1588 Clock
997-01510-03, Rev. C, 12/12/2006
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
1
where:
For example, enter:
F131 B4 PROTOCOL 16 ENABLE DISABLE
Response (one of the following lines):
OK - Protocol Settings have been received and applied by the PTP Option Card<CR><LF>
Request the PTP Subdomain Name
To request the PTP Subdomain Name, use the following format:
F131 B<N> SDN<CR>
For example, enter:
F131 B4 SDN
Response (example):
F131 B4 SDN _DFLT <CR><LF>
Set the PTP Subdomain Name
To set the PTP Subdomain Name, use the following format:
F131<SP>B<N><SP>SDN<SP>SUBDOMAIN
F
= ASCII character F
131
= unit function number
<SP>
= space
B
= ASCII letter to denote Option Bay number follows
<N>
= Option Bay Number, 1 through 4.
PROTOCOL = specify PTP Protocol command
<SI>
= Sync Interval in seconds, 1, 2, 8, 16 and 64
<BS>
= Burst Setting, ENABLE or DISABLE
<PO>
= PTP Port Setting, ENABLE or DISABLE