Set the ip address, Set the subnet mask, Set the default gateway – Symmetricom XLi IEEE 1588 User Manual
Page 132: Request the dhcp settings, Enable/disable dhcp, Request the ptp protocol settings, Request the ptp subdomain name, F131<sp>b<n><sp>ic<cr, F131<sp>b<n><sp>ip<sp>nnn.nnn.nnn.nnn<cr, F131<sp>b<n><sp>sm<sp>nnn.nnn.nnn.nnn<cr
124
XLi IEEE 1588 Clock
997-01510-03, Rev. C, 12/12/2006
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
1
Request the Internet Configuration (IP Address, Subnet Mask, Default Gateway) settings:
F131<SP>B<N><SP>IC<CR>
Set the IP Address:
F131<SP>B<N><SP>IP<SP>nnn.nnn.nnn.nnn<CR>
Set the Subnet Mask:
F131<SP>B<N><SP>SM<SP>nnn.nnn.nnn.nnn<CR>
Set the Default Gateway:
F131<SP>B<N><SP>G<SP>nnn.nnn.nnn.nnn<CR>
Request the DHCP settings.
F131<SP>B<N><SP>DHCP<CR>
Enable/disable DHCP:
F131<SP>B<N><SP>DHCP<SP>SET<CR>
Request the PTP Protocol settings.
F131<SP>B<N><SP>PROTOCOL<CR>
Enter the PTP Protocol Sync Interval, enable or disable Burst, and enable/disable the Port:
F131<SP>B<N><SP>PROTOCOL<SP>SI<SP>BS<SP>PO<CR>
Request the PTP Subdomain Name:
F131<SP>B<N><SP>SDN<CR>
Reset the PTP Parameters to the Factory Default settings:
F131<SP>B<N><SP>RFD<CR>
Initialize the PTP Protocol to the user-entered settings:
F131<SP>B<N><SP>INIT<CR>
Request the configuration of the PTP reference clock:
F131<SP>B<N><SP>C<CR>
Enter the PTP reference clock configuration for the PTP clock Master/Slave and Pri/Sec/Stby:
F131<SP>B<N><SP>C<SP>MS<SP>PSS<CR>