Smart Inventions SMART Height-Adjustable Wall mount HAWM-UX/UF - Manual (Page 11)

7 | CHAPTER 2 – CABLING AN 885ix SYSTEM TO A HAWM-UX/UF
3. Secure the mobility switch cable using a Phillips® No. 2 screwdriver and the two
screws listed inside the HAWM-UX/UF installation guide. Secure the cable toward
the side of the interactive whiteboard where you choose to mount the mobility
switch and make sure that the cable is toward the bottom of the switch as you
mount it.
4. Place the cable through the
HAWM-UX/UF’s lower cable
clip, making sure that the
cable is taut between the
interactive whiteboard and
the clip, and loose between
the clip and the base of the
HAWM-UX/UF.
5. Bundle the excess cable,
making sure that there is a
minimum of 28" (71.1 cm)
excess straight length or a
14" (35.6 cm) loose loop of
cable.
Placing cables for HAWM-UX/UF-mounted
components
To prevent cable friction, SMART recommends that you first place the cables that
don’t shift after they’re installed. Cables that connect components mounted to the
HAWM-UX/UF don’t shift after they’re installed. The wire management bundle (WMB)
shifts only if it’s connected to the wall or to the guest computer.