Smart Inventions SMART Height-Adjustable Wall mount HAWM-UX/UF - Manual (Page 24)

20 | CHAPTER 2 – CABLING AN 885ix SYSTEM TO A HAWM-UX/UF
5. When connecting
cables from the
projector to the
interactive
whiteboard, make
sure that all cables
pass between the
two wall-mount
interactive
whiteboard brackets.
Once the cables are
through the
brackets, place the
harness cable
toward the left side
of the interactive whiteboard for proximity to the left-mounted ECP.
6. Attach the cables to the lower cable clips on the HAWM-UX/UF. If you have many
cables attached, smoothly bundle your peripheral device cables together using a
cable tie (not included).
7. Attach a cable management clip (not included) to the cables or cable bundles,
making sure there’s a minimum of 28" (71.1 cm) excess straight length or a 14"
(35.6 cm) loose loop of cable.
8. If you don’t want to connect a network cable, proceed to the next step. Otherwise,
connect the other end of the network cable to your LAN port.
9. Connect the other end of the cables to your peripheral devices.
10. Slowly test the movement of the unit, using the HAWM-UX/UF’s mobility switch.
Make sure the cables aren’t taut at any range of the HAWM-UX/UF’s movement. If
they’re still taut, repeat this procedure until you find a suitable mounting location or
length for the cables.
ECP RCA
connector pod