Smart Inventions SMART Height-Adjustable Wall mount HAWM-UX/UF User Manual
Page 46
40 |
CHAPTER 4 – CABLING A 685ix OR D685ix SYSTEM TO A HAWM-UX/UF
Connecting your SMART UX60 projector’s ECP harness
cable
The ECP harness cable controls all signals and commands sent between the ECP
and the projector. Choose a side of the interactive whiteboard to install your ECP on,
and then follow the instructions in the SMART Board 685ix and D685ix Interactive
Whiteboard System Installation Instructions (
To connect your
projector’s ECP harness
cable
1. Attach the SMART UX60 projector’s ECP harness cable to the projector by
attaching the composite video RCA jack, its associated dual channel audio input
(two RCA jacks), the 4-pin power mini-DIN connector and the 7-pin mini-DIN
connector to the projector’s connection panel, as listed on the projector
connection panel (see page 38).
2. Place the harness cable
through the cable
management clip located
under the projector. Make
sure the harness cable’s
strain relief sits above the
clip point.
IMPORTANT
To add slack to the
cable, move the cable
to the clip’s
foam-padded section,
increase the length of
cable between the clip
and the projector and
close the clip.
2
USB A jack (recommended location for interactive whiteboard USB
cable)
3
DB15 ECP connector (reserved for ECP harness cable)
Number
Function