Smart Inventions SMART Height-Adjustable Wall mount HAWM-UX/UF User Manual
Page 86
80 |
CHAPTER 6 – CABLING A 600I3 OR D600I3 SYSTEM TO A HAWM-UX/UF
Using the SMART UF55 and SMART UF55w projector
connection panel for SBA and SBA-L projection audio
systems
The following diagram and list identify the SMART UF55 and SMART UF55w
projectors’ connections to SBA and SBA-L speakers. To access the cable channel,
remove the input/output cover on the left side of the projector and remove the cable
covers. For more information, see the SMART Board 600i3 and D600i3 Interactive
Whiteboard System Configuration and User’s Guide (
).
To connect your projector
to your speakers
1. Retrieve the 3.5 mm jack to dual channel audio output (two RCA jacks) cable from
the SBA-L packaging. This is the audio connection cable.
NOTE
The SBA packaging doesn’t contain a cable of this type. You must supply your
own cable of a suitable length.
2. Pass the audio connection cable through the boom. Place the cables in the left
side of the cable slot.
3. Connect the audio connection cable to the projector’s connection panel (see
above).
Number
Function
1
3.5 mm audio-output connector (recommended for SBA/SBA-L
speakers)
1