Smart Inventions SMART Height-Adjustable Wall mount HAWM-UX/UF - Manual (Page 47)

41 | CHAPTER 4 – CABLING A 685ix OR D685ix SYSTEM TO A HAWM-UX/UF
3. Place the harness cable
around the back of the
HAWM-UX/UF’s interactive
whiteboard brackets toward
the left side of the interactive
whiteboard if the ECP is
mounted on the left or toward
the right side of the
interactive whiteboard if the
ECP is mounted on the right.
4. Place the harness cable
through the upper cable clips
on the side of the
HAWM-UX/UF.
5. Connect the DB15M harness
cable’s plug to the ECP’s DB15 connector (see page 38).
Connecting the SMART UX60 projector to the wire
management bundle (WMB)
SMART recommends that when the WMB isn’t in use, you use the WMB’s magnetic
connection to attach the WMB to the HAWM-UX/UF’s moving frame. By doing so, you
prevent the WMB from shifting as the HAWM-UX/UF rises and descends.
CAUTION
When attaching a guest computer or laptop to the projector system, make sure
that it is not pulled by the HAWM-UX/UF at its lowest or highest height.
NOTE
If you choose to connect the WMB to the wall-mounted magnetic clip, do so at a
height and location that doesn’t interfere with the HAWM-UX/UF’s movement.
To connect your
projector’s WMB
1. Connect the WMB to the projector by attaching the HD-DB15 connector and the
3.5 mm audio jack to the projector’s connection panel (see page 38).
NOTE
The USB A plug doesn’t connect to the projector’s connection panel.
Upper cable
clips